BAIJIAN - Third party testing organization
The exterior wall insulation system with adhesive powder polystyrene particles is a structural system installed on the outer side of the exterior wall、 consisting of an interface layer、 adhesive powder polystyrene particle insulation layer、 anti crack protection layer、 and decorative layer、 playing a role in insulation、 protection、 and decoration. The basic structure of the adhesive powder polystyrene particle external wall insulation system is composed of a basic wall surface、 an interface layer、 a crack resistant protective layer、 and a decorative layer The project technical requirements for weather resistance shall not show cracking、 hollowing、 or detachment after 80 cycles of high temperature (70 ℃) - water spraying (15 ℃) and 20 cycles of heating (50 ℃) - freezing (-20 ℃). The tensile bonding strength between the crack resistant protective layer and the insulation layer should not be less than 01MPa、 and the failure interface should be located in the insulation layer. Water absorption/(g/㎡) immersion for 1 hour ≤ 1 000C type ordinary type (single mesh) 3J impact qualified impact strengthened type (double mesh) 10J impact qualified T-type wind pressure value not less than the wind load design value of the engineering project. It is resistant to freezing and thawing、 30 cycles in severe cold and cold areas、 and 10 cycles in hot summer and cold winter areas. The surface is free from cracks、 hollowing、 bubbles、 and peeling. The water vapor wet flow density/g/(㎡· h) ≥ 0.85. The inner side of the waterproof sample protective layer is water free、 permeable、 and wear-resistant、 No cracking、 cracking、 or peeling of surface protective layer or damage to the system within 500L seconds. The tensile strength (C-type)/MPa ≥ 0.1 and the damaged part should not be located at the interface of each layer. The bonding strength (T-type)/MPa (on-site sampling) ≥ 0.4. The seismic performance (T-type) is below the seismic intensity level. The brick surface and external insulation system should not be ignited without detachment. After the test、 the thickness of the test piece should not change by more than 10%
Function of testing report:
1. Project bidding: Issue authoritative third-party CMA/CNAS qualification report
2. Online e-commerce platform entry: Quality inspection report recognized by major e-commerce platforms 3. Used as a sales report: issuing legally effective testing reports to make consumers more confident 4. Papers and research: Provide professional personalized testing needs 5. Judicial services: providing scientific、 fair、 and accurate testing data 6. Industrial problem diagnosis: Verify the troubleshooting and correction of industrial production problemsinspection and testing process:
1. Telephone communication and confirmation of requirements
2. Recommend solutions and confirm quotations 3. Mail samples and arrange testing 4. Progress tracking and result feedback 5. Provide reports and after-sales service 6. If urgent or priority processing is requiredTesting and testing characteristics:
1. The testing industry is fully covered、 meeting different testing needs
2. Fully cover the laboratory and allocate localized testing nearby3. Engineers provide one-on-one services to make testing more accurate
4. Free initial testing、 with no testing fees charged
5. Self service order delivery for free on-site sampling
6. Short cycle、 low cost、 and attentive service 7. Possess authoritative qualifications such as CMA、 CNAS、 CAL、 etc 8. The testing report is authoritative and effective、 and is generally used in China